Aurora 1000 INTEGRATING NEPHELOMETER Easy to use and maintain, the Aurora 1000 lowers the cost of ownership for aerosol light scattering, visibility and particulate monitoring instrumentation. The Aurora 1000 Integrating Nephelometer uses a single wavelength for scattering coefficient visibility measurements at one of three user specified wavelengths. ACOEM Ecotech, through collaboration with globally renowned atmospheric research institutes, now provides the scientific community with the most advanced commercially available nephelometers. Using a single wavelength LED light source, the Aurora 1000 can be equipped with any of the following light sources: • 450 nm (blue) for fine and ultra fine particulates (wood fires, automobiles) • 525 nm (green) for visibility • 635 nm (red) for large particulates (e.g. pollen, sea salt). BENEFITS • Simplified automatic calibration using internal valves, ideal for remote locations. Fully automatic zero check or adjust, automatic span check or automatic zero and span check available in intervals of 1, 3, 6, 12, 24 hrs or weekly • Fully integrated package including: internal sample pump, sample heater, internal calibration valves, zero air pump and data logger • Internal sample heater with temperature or RH control, which can be enabled by the user to eliminate the effects of humidity (RH: < 30 to < 90 % ) • 12 VDC operation (60 watts max, 13 watts nominal) • Holds up to 61 days of 5 minute data averages or 2 days of 1 min data • Data downloading and firmware upgrading software supplied on USB or internet. Increased accuracy • Automatic calibration • Easy maintenance/cleaning of the measurement cell • Long lasting LED light source • Intuitive software and maintenance • Automatic optical reference calibration • Facilitates a wide measurement range (0 to 20,000 Mm -1 ). LED vs flash lamp • Our LED light source is guaranteed not to fail and often exceeds 5 years, compared to a flash lamp that is recommended to be changed every 4 - 6 months • Heat generated by the LED light source is a fraction of that generated by a flash lamp, minimising changes in sample RH • LEDs emit light at a specific wavelength eliminating the need for band pass filters. Lower cost of ownership • Fully automatic zero and span calibrations • Low power internal 12 V heater eliminates the need for external inlet heater • Long lasting low power LED light source • No bandpass filters to be replaced • Unique in its simplicity and practicality.
"Very efficient. Competitive pricing. The reminders, I’m so busy in my job that it’s so great to have a reminder to do something. It really helps me.
I’m very happy".
- Tim Cannon – Research and Development Manager; Pecan Engineering Pty Ltd